Nighthawk MS70 is satellite that connects to the Nighthawk router and enhances the internet speed throughout your house. If you are facing connectivity problems with your Nighthawk MS70 satellite, then you need to read this blog to solve these problems. This blog help you to solve your question why is my Nighthawk ms70 satellite not connecting to router or internet. Let’s start:
Take Steps to Resolve This Issue
Here we discuss in detail about all the troubleshooting tips to solve the problem Nighthawk ms70 satellite not connecting to router.
Check Connection
First of all you need to check your Nighthawk router is properly connected to the modem, and the Nighthawk MS70 satellites are correctly connected and configured to the router. If your router not connects to internet, then check there is no any internet issue in your area, if any then call your ISP.
Hardware Connection
Make sure there is no any physically damage in the network and power cables. Check all the cables are in good condition and no any damage in it, if any fix it. Also check your mesh devices get proper power supply.
Relocate and Re-sync the Satellite
Sometime users place the satellite out of the router’s range. It is the common reason, due to which you can face issue with Nighthawkms70 satellite. To solve this, relocate the satellite within the range of the router.
After re-locate the satellite, perform the sync process between the router and the satellite again. To sync, push the sync button of the router and within 2 minutes push the sync button of the satellite.
Power Cycle the Network
Power cycles all the network devices in your home. There is difference between power cycle and power cycle process. To power cycle, turn off the devices and plug out all the power and network of the Nighthawk mesh devices. After sometime, connect all the cables properly and turn on all the devices.
Reset the Devices.
If you have followed all the steps given above, but you still faced the problem, then you need to reset the mesh devices. Reset process is used for restore all factory default settings.
To reset, simply find and press the reset button that present on back side of the nighthawk mesh devices. Hold it for few seconds and release it. Amber light is blink on the device, wait until the light is become stable. It will take few seconds to complete. Re-configure the router and the satellite after reset.
Conclusion
In the above post, we provide the best solution for your problem why is nighthawk ms70 satellite not connecting to router? Just follow all the steps one by one and carefully.